nismus des Via Epia ======
Via Epia unterstützt Powersave: kann Frequenz runterregeln. Bei Linux macht ... governors:
modprobe longhaul
modprobe cpufreq_powersave
Check using the dmesg command to see if it l... ry boot. For this - just add longhaul and cpufreq_powersave into the /etc/modprobe.preload file.
Using ... accordingly. If you want to stick the system into powersave mode - load the cpufreq_powersave.ko module
>
By default a switch toggles the corresponding power state (e.g., Switch1 controls Power1). Every time the switch gets flipped the power state of the relay toggles.
Damit zusammenhängend:
Ein... <x> 15</code> you can decouple Switch<x> from its power output and it will instead send MQTT messages in
B' 'GiB'</td><td>Unit conversion (<acronym title="powers of 10">SI</acronym> to <acronym title="powers of 2">IEC</acronym> prefixes)</td></tr>
<tr><td>•</td><... >#</td><td class="nw">smartctl -A /dev/sda | grep Power_On_Hours</td><td>How long has this disk (system) been powered on in total</td></tr>
<tr><td>#</td><td class
d start them pressing ENTER.
To shutdown select "PowerOff" in the menu, or simply power-off the PC.
==== Game Play ====
In the game play you can use the follo
PDB Displays current status of the Power Driver Board
Usage:
pdb
P...
Remove the PRISM board, plug in a keyboard and power up the box. If you are lucky and the monitor "syn... the PRISM board/plug in PC monitor and keyboard
Power up (you will see the normal PC BIOS startup becau... m of the cabinet. The cube has a little wall-wart power supply that you can plug into the utility power o
udo paython pir_test.py
#
# NOTE: Won't work with power saving screen blanking.
# Written for Raspberry... perion-ambilight-ohne-l%C3%B6ten.112/]]
[[http://powerpi.de/atemberaubendes-ambilight-am-eigenen-tv-selb
kernel: hiddev96: USB HID v1.10 Device [American Power Conversion Back-UPS CS 350 FW:807.q5.I USB FW:q5]... or "RFC" where APC is the powernet MIB,
# "APC_NOTRAP" is powernet with SNMP trap
# ca... #
# ======== Configuration parameters used during power failures ==========
#
# The ONBATTERYDELAY is th