====== Fehlermeldung LANG ======


Falls eine dieser Fehlermeldungen:
<code>
manconv: can't set the locale; make sure $LC_* and $LANG are correct
</code>
oder
<code>
perl: warning: Setting locale failed.
perl: warning: Please check that your locale settings:
        LANGUAGE = "en_US:en_GB:en",
        LC_ALL = (unset),
        LANG = "en"
    are supported and installed on your system.
</code>
 had the same problem. I fixed it by deleting the lines in
 /etc/locale.gen
 and removing the package locales and re-installing it
 <code>
apt-get remove locales
apt-get install locales
</code>
Upon re-installing you will be asked which locales to generate. I ran into some other issues because I installed the package localepurge. Remove this if you have it, it will mess up the initial locale gen.
 If you have other problems try
 <code>
dpkg-reconfigure locales
</code>

To close off this issue and for future problems:
  
<code>sudo localedef -i lang-f /path/to/charmap lang
</code>
where lang  is your language (en_US)

 and charmap  is UTF-8, 

 just run locate UTF-8 to find the path.